ELFP4H(4 (444###@$ĴĴ /lib/ld-linux.so.2GNU   )e'"0E*MȄ#"t؄eF/>= (1m8*7{ libc.so.6getopt_long__strtol_internalusleepperroroptargiopermfprintf__deregister_frame_infostrncmpsscanfstderr_IO_stdin_used__libc_start_main__register_frame_info__gmon_start__GLIBC_2.0ii صĵ ȵ ̵ е Ե US[@1 >[5%%h%h%h%h%h %h(%h0%ĵh8p%ȵh@`%̵hHP%еhP@%ԵhX01^PTRhܒhPQVh0US[0<t[ÉU= u>PС8uȄt h ÐUUthhÐUÐUWVSEDžxx|t11DžpDžlDžh[8O$&lh0%t&t&pt&t&jh5uD@<5t` <2t"S fj<&0S fj<S fG@S f﹀>S ff}Ix+=t1>)PVWh 5VWh`5e[^_ÉUVSu111ҍBv uV1V1B~߉11% ‰[^ÉU WVS}u U]w9tK=t#SRhSV PwPSRhvfwv1e[^_ÍUS=t Ѓ;u[UUS[ô"[3c5x9setup.c:v1.00 6/19/2000 Donald Becker (becker@scyld.com) http://www.scyld.com/diag/index.html Usage: 3c5x9setup [-aEfFsvVw] [-p ] [-F 10baseT|10base2|AUI>] [-Q ] write-EEPROMversionverbosenew-irqnew-IOaddressnew-hwaddrnew-interfaceforce-detectionemergency-rewritehelpshow-eepromdebugshow-all-registersnew-base-addressbase-addressCommand in ProgressDMA in ProgressUpload CompleteDownload CompleteDMA DoneStatistics FullDriver Intr RequestRx Early NoticeRx CompleteTx AvailableTx CompleteAdapter FailureInterrupt latch This network adapter has unhandled interrupts! This should never occur with properly configured adapter. You may have a hardware interrupt conflict. Check /proc/interrupts to verify that the interrupt is properly registered, and that the count is increasing. This problem is frequently solved by moving the adapter to different IRQ. For ISA cards, verify that the BIOS setup has assigned the IRQ line to ISA bus. For PCMCIA cards, change the configuration file, typically named /etc/pcmcia/config.opts, to use a different IRQ. aDeEfF:hi:p:P:Q:svVwX:10baseAUIInvalid interface specified: it must be 0..3, '10base{T,2,5}' or 'AUI'. %2x:%2x:%2x:%2x:%2x:%2xInvalid new IRQ %#x. Valid values: 3-5,7,9-15. Invalid new I/O address %#x. Valid range 0x200-0x3f0. 3c5x9setup: ioperm()This program must be run as root. No EtherLink III device exists at address 0x%X. Use the '-f' option proceed anyway. INo i %snterrupt sources are pending. %s indication. A potential 3c5*9 has been found, but it appears to still be active. Only limited information is available without disturbing network operation. Either shutdown the network, or use the '-f' flag to see all registers. Available Tx room %d bytes, Tx/Rx Status %4.4x / %4.4x. An interrupt occured only %d ticks ago! 3c5x9 found at %#3.3x. 3c5*9 not found at %#3.3x, status %4.4x. If there is a 3c5*9 card in the machine, explicitly set the I/O port address using '-p Indication enable is %4.4x, interrupt enable is %4.4x. Carrier LostHeartbeatTx Multiple collisionsTx Single collisionsTx Late collisionsRx FIFO overrunsTx packetsRx packetsTx deferrals(256 Rx/Tx counts)Rx bytesTx bytesYfp˜֜ Event counts: %s is %d. Window %d: %4.4x. completedfailedEEPROM read of index %d %s after %d ticks -> %4.4x. Caution! Last-chance EEPROM write requested. The new EEPROM values will not be written without '-E -E -E -w' flags. IRQtransceiver/IOchecksum (The new EEPROM values will not be written without the '-w' flag.) ІЈ`ƈӈ10baseTundefinedBNC EEPROM contents: %s %4.4x Model number 3c%2.2x%1.1x version %1.1x, base I/O %#x, IRQ %d, %s port. 3Com Node Address %2.2X:%2.2X (used as a unique ID only). OEM Station address %2.2X (used as the ethernet address). Manufacture date (MM/DD/YY) %d/%d/%d, division %c, product %c%c. disenforce fullhalf Options: %s duplex, %sable linkbeat. ****CHECKSUM ERROR****: Calcuated checksum: %4.4x, stored checksum %4.4x. The computed checksum matches the stored checksum of %4.4x. EEPROM wrote index %d with 0x%4.4x after %d ticks! Failed to write EEPROM location %d with 0x%4.4x! Writing new %s entry 0x%4.4x. Would write new %s entry 0x%4.4x (old value 0x%4.4x).  pPwaqDee`hNE>f0F%HPQvVw`PD7+ܔ̔ ;XN6ADPm ;<4 P ܒ(Ȃ `؃oooĴ΄ބ.>GCC: (GNU) 2.95.4 20011002 (Debian prerelease)GCC: (GNU) 2.95.4 20011002 (Debian prerelease)GCC: (GNU) 2.95.4 20011002 (Debian prerelease)GCC: (GNU) 2.95.4 20011002 (Debian prerelease)GCC: (GNU) 2.95.4 20011002 (Debian prerelease)GCC: (GNU) 2.95.4 20011002 (Debian prerelease)01.0101.0101.0101.0101.0101.01.symtab.strtab.shstrtab.interp.note.ABI-tag.hash.dynsym.dynstr.gnu.version.gnu.version_r.rel.dyn.rel.plt.init.text.fini.rodata.data.eh_frame.dynamic.ctors.dtors.got.bss.comment.note# 1((7 ?ȂGo"To c ؃l ` uPP%pxx{PP ܒ # $Ĵ$%%%@%` % 'xx',? 3(Ȃ؃ P x P ܒ Ĵt t t ' 26D P fy   '  Ԓ ܒ 0  $"-8  E8r OR b+ o|e(Ĵ@4'"*  @)3EKP QȄ#"tP ؄ ܵ0  !/3ܒ 9=K(1b8*tܵ{@ Letextgcc2_compiled.call_gmon_startcrtstuff.cp.3__DTOR_LIST__completed.4__do_global_dtors_aux__EH_FRAME_BEGIN__fini_dummyobject.11frame_dummyinit_dummyforce_to_data__CTOR_LIST____do_global_ctors_aux__CTOR_END____DTOR_END____FRAME_END__3c5x9setup.cversion_msgusage_msgset_hwaddrnew_hwaddrwrite_eepromdo_updatecalculate_checksumprint_eeprom__dso_handleusleep@@GLIBC_2.0opt_flongopts_DYNAMICintr_names__register_frame_info@@GLIBC_2.0_fp_hwperror@@GLIBC_2.0fprintf@@GLIBC_2.0verboseioaddrshow_eepromnew_ee_contentsshow_regsintrs_pending_msgdebug_init__deregister_frame_info@@GLIBC_2.0stderr@@GLIBC_2.0_start__strtol_internal@@GLIBC_2.0djb_eepromdo_write_eepromstrncmp@@GLIBC_2.0__bss_startmaineeprom_contents__libc_start_main@@GLIBC_2.0data_startprintf@@GLIBC_2.0_finiioperm@@GLIBC_2.0getopt_long@@GLIBC_2.0sscanf@@GLIBC_2.0_edata_GLOBAL_OFFSET_TABLE__endoptarg@@GLIBC_2.0_IO_stdin_used__data_start__gmon_start__